Use: apply to a variety of fabrics stretch blank range and scope of the bad cylinder knitting cloth material Cut bundle, is tied specialized processing plant article, garment factories, knitting underwear factory. Factoryr bundle side, tied collar, purfle, panel strip use ideal product.
The main technical parameters：
1.Article rolling shear plate number: 1 〜3
2.Article scissors roll width：16 〜60mm (Single)，15〜80mm（Double），15〜54mm（three knives）
3.Article roller width of error: ±1.5mm
4.Shear be the largest roller width:160mm(60 〜 160mm scope of the use of single-tool pole proposal).
6.Host to the pace of expansion：120RPM〜1300RPM.
7.Motor chassis: 120RPM 〜 1300RPM.
8.Roll length of the article：1m〜9999m.
9.Wide green cloth: 495MM 〜2500MM.
10.Fine-tuning chassis：-100 to +100.
11.Working voltage: 220V (50Hz)
1.The blue liquid crystal display touch-screen keyboard operation.
2.Wtork.power-down memory function of power before the data automatically to restore electricity.
3.Fault Detection，Prompt functions，failure to facilitate the automatic
4.With a computing speed automatic detection compensation, to adjust the speed of the host can auTomatically adjust the chassis.
5.Single,double，three knives, with a memory switch.
6.CD with all The speed of the expansion of functions, can improve the efficiency of the half.
7.Chinese and english conversion function.
8.Chassis fine-tuning with automatic functions into the poor ,the computer will automatically adjust the width of the pieces of cloth, when the fine-tuning over the limit.
9.Article rolling plate with automatic and cumulative function
10.Host speed, wide green cloth, fine-tuning the chassis, roll length of the article have any time to change functions.
11.Darg system with automatic protectiove function..
12.Transmission using bearing grease，do not to worry about oil leak or fuel.
13.Light transmission, host complex chain transmission, so that the operation to maintain lower noise and more convenient.
14.It is easy to operation for the width of the regulator through the regulation round of the hand.
15.Adjust the angle of friction wheel design features, easy operation and flexible regulation, combined width of the regulator's hand to reach rmitid oi‘the regulation combined width of the regulator’s hand to reach round of the regulation
width. Of the roll be the ideal width.
16.Chassis design of the slip functions, chassis card to avoid death or lead to excessive external force to promote electrical burn.
17.Draging, winding roll system uses a new type of variable article can be based on the clastic fabric to adjust its size and draging, winding be rolling speed, the adjustment knob for adjusting hidden button (to avoidnon-operators to mobilize and influence the normal operation of the shear ).
18.Computcr control and manual control of General Motors, used for manual operation Of only Operation panels can be replaced.
19.Cloth around the roll using a unique set of principles of magnetic beads in place of the original block structure, so that the operation more flexible, while reducing the wear and tear of the body, there is no need for maintenance.